Just got all the hardware set up and working today, super stoked!

In the pic:

  • Raspberry Pi 5
  • Radxa Penta SATA hat for Pi
  • 5x WD Blue 8TB HDD
  • Noctua 140mm fan
  • 12V -> 5V buck convertor
  • 12V (red), 5V (white), and GND (black) distribution blocks

I went with the Raspberry Pi to save some money and keep my power consumption low. I’m planning to use the NAS for streaming TV shows and movies (probably with Jellyfin), replacing my google photos account (probably with Immich), and maybe steaming music (not sure what I might use for that yet). The Pi is running Raspberry Pi Desktop OS, might switch to the server version. I’ve got all 5 drives set up and I’ve tested out streaming some stuff locally including some 4K movies, so far so good!

For those wondering, I added the 5V buck convertor because some people online said the SATA hat doesn’t do a great job of supplying power to the Pi if you’re only providing 12V to the barrel jack, so I’m going to run a USB C cable to the Pi. Also using it to send 5V to the PWM pin on the fan. Might add some LEDs too, fuck it.

Next steps:

  • Set up RAID 5 ZFS RAIDz1?
  • 3D print an enclosure with panel mount connectors

Any tips/suggestions are welcome! Will post again once I get the enclosure set up.

  • ramenshaman@lemmy.worldOPEnglish
    1·
    2 days ago

    they could include a “mini UPS” to keep 12v/5v up long enough to shut down gracefully in a power loss scenario

    That’s a fuckin great idea.

    • r00ty@kbin.life
      1·
      2 days ago

      I was looking at doing something similar with my Asustor NAS. That is, supply the voltage, battery, charging circuit myself, and add one of those CH347 USB boards to provide I2C/GPIO etc and just have the charging circuit also provide a voltage good signal that software on the NAS could poll and use to shut down.

      • ramenshaman@lemmy.worldOPEnglish
        0·
        2 days ago

        Nice. For the Pi5 running Pi OS, do you think using a GPIO pin to trigger a sudo shutdown command be graceful enough to prevent issues?

        • r00ty@kbin.life
          1·
          2 days ago

          I think so. I would consider perhaps allowing a short time without power before doing that. To handle short cuts and brownouts.

          So perhaps poll once per minute, if no power for more than 5 polls trigger a shutdown. Make sure you can provide power for at least twice as long as the grace period. You could be a bit more flash and measure the battery voltage and if it drops below a certain threshold send a more urgent shutdown on another gpio. But really if the batteries are good for 20mins+ then it should be quite safe to do it on a timer.

          The logic could be a bit more nuanced, to handle multiple short power cuts in succession to shorten the grace period (since the batteries could be drained somewhat). But this is all icing on the cake I would say.