Recently I’ve gave up Windows for Linux and installed Ubuntu with KDE Plasma desktop on my pc and laptop from 2007. It’s an i7 Intel processor with 8gb ddr ram so I thought it would be fine, but it seems quite sluggish. What distro could I use that would be faster and still fully functional? Thanks for your help in advance.
I think Zorin Lite OS will be good distro for a old laptop becuase I also install this distro on my very old computer(16 Years Old and have 2gb ram and Pentium Processor) and It work fine.
KDE should run fine on those specs, I would try to replace the hard drive, I had one of those slow down a Laptop to a point where I almost threw it away but with a new one everything worked fine again. If it doesn’t I would say as a beginner Linux Mint with ether XFCE or Mate should be a great choice but I doubt you need it with those specs tbh!
I’ve ordered an ssd so hopefully that will do the trick. Meanwhile I installed openSuse and it improved the speed significantly.
I don’t think it’s a SSD vs HDD situation (both should work perfectly fine with any DE) but rather a case of old and dieing HDD, that’s at least what caused my system to fuck up two years ago or somethimg like that. There are systems that work better on far slower than HDD (today only “achived” by dieing HDDs) speed tho so I could imagine that improving the situation, just don’t sotre important stuff on that till you got a new drive!
The ssd made a world of difference! I don’t think the old hdd is dying, the system still worked well with the original win7, but now everything is blazing fast.
I’d try Xubuntu or Lubuntu, but honestly KDE should run fine on those specs.
I suspect it has an HDD: you’ll get a much more noticeable boost from upgrading to a $35 SSD than any distro choice will give you.
Can confirm. I had a 2007 laptop (Compal FL90) with far worse specs. Core 2 Duo T7100 (I upgraded it to T7500, small difference), Nvidia GeForce 8600M GT, 4GB DDR2 RAM (previously 3GB). Then I replaced the original 80GB Fujitsu HDD made in September 2006 for a cheap SSD. Damn. I started using that laptop most of the time. It felt way faster than my main laptop (with SMR HDD).
I got extra 2 years out of it before it died. I really miss that laptop.
Edit: I ran Linux Mint Cinnamon and Windows 11 on it. Yes, 11.
Why would you upgrade your worst laptop with ssd?
- I was taking it to school. I didn’t really have to worry much about this laptop. I got it for free, it wasn’t worth too much, and it was an indestructible brick.
- Storage size. I needed more storage in my main laptop while 128GB was enough for this one.
- Reliability. This was SSD from AliExpress (XrayDisk). Not reliable enough for a main machine. And indeed, 2 years later and it has corrupted sectors.
- Ease of replacement. This old laptop only required unscrewing 1 screw to replace the HDD. Originally it would be 4, but they were missing along with HDD caddy. Meanwhile checking video on how to open my main laptop… I’d probably tear some wires, break the plastic and also destroy the rubber feet which are somehow quite expensive.
If you’re married to Ubuntu, I’d suggest Xubuntu. It’s Ubuntu using the XFCE desktop environment. XFCE can be a little… hard on the eyes by default, but it’s super lightweight, very stable, and very customizable. It can be a very aesthetically pleasing DE with a little theming and an icon pack.
Outside of Ubuntu, Id suggest Linux Mint with XFCE. I know, I know, Linux Mint is based on Ubuntu so why bother? Well, it’s not Canonical. They’ve done some great things over the years, but recently… I just tend to stay away.
Personally, I use OpenSUSE Tumbleweed. Love it, I’ll never leave it. It’s amazing. But without knowing your personal preferences or use cases, and with the info in your post, I have to recommend Xubuntu or Linux Mint XFCE. Also I agree with the other commenter, you’d benefit a lot from an upgrade to an SSD.
Well, I’ve ordered ssd and installed openSuse tumbleweed. I like it and it’s much snappier too, but the command line is different to ubuntu and I don’t think i want to learn two sets of commands. I guess I’ll have to decide which way I want to go.
You won’t go wrong no matter which you end up choosing. I am personally a huge fan of the way OpenSUSE runs their ship, and some of the tools there are incredible.
YaST, for example, is a system management tool that provides the most extensive GUI for managing your system settings I’ve seen on a Linux distro period. Yes, all the settings can be managed from a terminal, but it’s nice to have a graphical option sometimes.
Just play around with it since you’ve already got it installed, and see how you like it. There’s a strong and friendly community surrounding the distro, so reach out if you’ve got any questions! You’re also welcome to ask me. I may not have all the answers, but I’m pretty certain I can find someone who can help lol.
I’ve tried a few distos, but as for you, opensuse is the way to go for me. I got a new ssd to replace my old hdd and it’s super fast. The new OS is like a shiny new toy that will keep me entertained for awhile. In the end, I’m just a normal person and won’t need most of the features, but it’s nice to have them.
If you haven’t yet, I would run the following commands:
sudo zypper install opiopi codecsThis will enable the Packman repositories (repos will commonly used non-free software, like multimedia codecs) and install multimedia codecs for watching videos and playing music and the like.
Anyway, I’m glad you’re enjoying OpenSUSE! It’s a delightful distro and community.
Debian XFCE
Ubuntu uses snaps, which I’ve found sluggish on older ide hard drives. To be honest, even flatpaks are very slow for these in my experience.
I think you might be better off with
opensuse tumbleweed.Novelty recommendation besides tumbleweed:
antix.While I haven’t used
antixexcept out of curiosity in a virtual machine, they are lightweight, but they have a hard stance against systemd.Thanks, I have installed tumbleweed today and I like it. It is much faster too. I’m unsure about learning two different sets of commands just when I’m switching. I guess I have time to decide until my ssd arrives.
I’ve used a lot of distributions over the years, and I don’t think you have to worry about a different set of commands across most distributions. It’s some variation of
distropkgmgrfollowed by command, where command, where command is generally one ofinstallupgraderefresh/updateremovesearchto name the most common. If you use a software frontend likegnome-softwareordiscover, you don’t even need to worry about command line differences.The only exception to that is
nixos, which I wouldn’t recommend to someone just switching. It is very cool, just needs more experience.The shell commands are the same one installed for the most part.
Out of curiosity, are you planning to use a different os when your ssd arrives? I switched from Ubuntu to endeavouros (Arch) to Opensuse tumbleweed on my primary laptop (i9 processor), no complaints 😁!
I’ll keep the desktop with ubuntu and kde plasma and I’ve installed openSuse tumbleweed on the laptop. The ssd made a huge difference. I’ve made it dual boot with win7, which I’ve reinstalled on the laptop and they’re both blazing fast. It’s a steep learning curve, but I like the freedom of Linux versus the big brother approach of Windows.
Very cool.
Interesting timing that opensuse recently announced slowroll, which has a slower cadence for updates (updates with monthly frequency, rather than daily, while security updates are still ASAP.
Depending on whether frequent updates is you thing or you prefer slightly delayed cycles… you can easily convert your install to
slowroll
To be honest, I don’t really care that much. Once upon a time I got excited about updates and new features, now I just want things to work. I enjoy exploring Linux and how it’s different, I like seeing the updates come in and it makes me feel safer, but at the end of the day, I’m just a normal user who needs much less than the OS offers.
Zorin OS Lite, or Xubuntu. Both are based on XFCE and should be a lot lighter than stock Ubuntu.
If you want something even lighter (still based on XFCE), Puppy Linux (QuickPup) might be a good option. One of the things that makes Puppy so fast is that it run entirely from RAM, so it doesn’t need to touch the HDD to access files. It saves all disk changes to an overlay filesystem which runs in the RAM, and when you’re done with your session, you get an option to save it do your HDD (there’s also an option to periodically save your session). Puppy can be a bit quirky but it really makes a big difference on an old system, so it’s definitely worth checking out IMO.
Thanks, I’ve ordered ssd and I’m trying opensuse now. Puppy linux sounds great for persistent usb set up. I’ll definitely try it.
deleted by creator
deleted by creator
Try archlinux+i3wm. This is best thing happened to my laptop 💻
It’s probably not the best idea to recommended arch to a beginner
He didn’t mention that he is newbie
they did, “Recently I’ve gave up Windows for Linux”
Is it a Core i7 or a Core 2 series processor? 2007 would suggest the latter, and I would absolutely argue for either that you really should prefer something with Xfce or a similar lightweight desktop (maybe Cinnamon or MATE).
I’d probably recommend Linux Mint as a lightweight user-friendly distro, and I’d suggest any of the three available variants based on what you like the most aesthetically.
Additionally, if you haven’t opened them up for a while, pick up an inexpensive SSD for both of them if they don’t have them already. Modern OSes really expect an SSD over a spinning disk as the boot drive.
I misremembered the specs it’s actually i7-2630m, which indicates that I thought I got the laptop later than I thought. I’ve ordered a ssd so hopefully that will improve the speed.
Removed by mod
